Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
- 1. The maintenance instruction
   1.1. Protection of environment and economy of energy
   1.2. A key
   + 1.3. A steering wheel
   1.4. Seats
   1.5. Headrests
   1.6. A seat belt
   1.7. Rear-view mirrors
   1.8. An adjustable external mirror with an electric drive
   1.9. The ignition lock
   + 1.10. Controls and control devices
   1.11. Body elements
   1.12. Luggage space increase at cars the Hatchback
   1.13. Luggage space increase at cars the Versatile person
   1.14. Adjustment of height of a back suspension bracket
   1.15. Safety
   1.16. Operation of belts
   + 1.17. Illumination
   1.18. Opening of glasses and the hatch
   1.19. Heating and ventilation
   1.20. An automatic transmission
   + 1.21. The catalyst
   1.22. An exhaust system, exhaust gases
   1.23. Instructions on driving
   1.24. Economy of fuel
   + 1.25. Wheels and tyres
   1.26. A spare wheel, a jack and the tool
   + 1.27. Bases of safe operation of the car
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

1.14. Adjustment of height of a back suspension bracket

THE GENERAL DATA

Adjustment of height of a back suspension bracket provides possibility at various level of congestion of the car behind including at driving with trailer, to support height approximately at constant level and considerably improves passableness of the car.

Manual adjustment is made by means of the automobile pump or the compressor. The nipple of the pumping up device is on the right side of a luggage space.

At full loading from safety reasons it is forbidden to go by the maximum superfluous pressure.

At a total load of the car pressure in the device should correspond to the minimum value 300 кПа (3 bar). In no event pressure should not be below base value 80 кПа (0,8 bar). Pressure is necessary for supervising periodically.

PERFORMANCE ORDER

1. Not loaded car establish on an equal horizontal platform. Fill the device with pressure 80 кПа (0,8 bar). Measure height of a back bumper over earth level, subtract from the received value of 5 sm and write down it.

2. If at car loading this size becomes less, increase pressure before achievement of former value. Do not lift pressure above a mark 500 кПа (5 bar).

3. Before a trip on not loaded car necessarily lower pressure to 80 кПа (0,8 bar).