Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   + 6.1. Models with the carburettor
   + 6.2. Models with system of injection of fuel
   - 6.3. Models with engines 16D and 16DA
      6.3.1. A technical characteristics
      6.3.2. Power supply system clearing
      6.3.3. Replacement of the air filter
      6.3.4. Replacement of the fuel filter
      6.3.5. Plums of fuel from the fuel filter
      6.3.6. A heating element of the fuel filter
      6.3.7. Check and adjustment of turns of idling
      6.3.8. Check and adjustment of the maximum turns
      - 6.3.9. The fuel pump
         6.3.9.1. Check and adjustment
         6.3.9.2. Removal, repair and installation of the fuel pump
      6.3.10. Removal and valve installation отсечки fuel of system of idling
      6.3.11. Removal, repair and installation of atomizers
      6.3.12. Removal and installation of a cable of an accelerator
      6.3.13. Removal and installation of a cable of system of cold start of the engine
      + 6.3.14. Collectors
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

6.3.9.2. Removal, repair and installation of the fuel pump
Removal

PERFORMANCE ORDER

1. Remove приводной a pump belt.

2. Disconnect a hose of giving of fuel (poses. And in drawing at the left) and a hose of the return pipeline (poses. In in drawing at the left, drawing on the right) the fuel pump.

3. Disconnect a wire and a cable from the pump.

4. Unscrew a nut of fastening of a pulley.

5. Remove a pulley from a pump shaft (drawing at the left). The arrangement шпонки is specified by an arrow in drawing on the right.

6. Unscrew fixing bolts and remove the pump.

Repair

Sealing ring of a shaft of the pump

The sealing ring is specified by an arrow.

The lever of a throttle and spring

Connections of fuel tubes of cylinders

A, B, C, D – an order of connection of fuel tubes of cylinders

PERFORMANCE ORDER

Replace the worn out consolidations and springs (fig. the Sealing ring of a shaft of the pump, fig. the Lever of a throttle and a spring, fig. of Connection of fuel tubes of cylinders see ). If the pump is faulty, it is necessary to address to experts.

Installation

PERFORMANCE ORDER

1. Installation is made in sequence, return to removal.

2. Fixing bolts of the pump tighten in the following sequence: A-v-s.