Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
- 9. Coupling
   9.1. A technical characteristics
   - 9.2. A coupling cable
      9.2.1. Adjustment of a cable of coupling
      9.2.2. Removal and installation of a cable of coupling
   9.3. Removal and installation of a pedal of coupling
   + 9.4. Coupling
   9.5. Removal and installation выжимного the bearing
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

9.2. A coupling cable

9.2.1. Adjustment of a cable of coupling

THE GENERAL DATA

The prevention
In 1989 a part of cars have been made with height of installation of a pedal of a brake on 15 mm above a coupling pedal. Normal installation of a pedal of a brake on 4 mm below a coupling pedal. If necessary adjust height of installation of a pedal of a brake for what change length of a pusher of the vacuum amplifier of brakes, rotating a plug on a pusher.

PERFORMANCE ORDER

1. At replacement of coupling or a coupling cable it is necessary to make initial adjustment of a cable of coupling.

2. Using a roulette, measure distance And from the centre of a rubber overlay of a pedal of coupling to a steering wheel in a starting position of a pedal of coupling and write down the measured value.

3. Press a coupling pedal against the stop and spend similar measurement (distance).

4. Define a course of a pedal of coupling for what subtract the first measurement from the second. The course of a pedal of coupling should correspond to technical requirements.

5. Otherwise adjust length of a cable of coupling as follows.

6. In a motor compartment remove скобу, крепящую a carving tip of a cable of coupling to the squeezing lever and rotating a regulator, adjust a coupling cable. Regulator rotation clockwise increases a pedal course, and counter-clockwise – reduces it.

7. Make repeated measurement of a course of a pedal and establish скобу, fixing a carving tip of a cable of coupling.

8. If coupling is maintained long time, probably, adjustment of a cable of coupling will not give result. It testifies to deterioration of frictional overlays of a disk of coupling and necessity of replacement of a disk of coupling.