Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
+ 4.1. Engine OHV (with a camshaft in the block of cylinders)
+ 4.2. Engines OHC
- 4.3. Engine DOHC with 16 valves
4.3.1. A technical characteristics
4.3.2. Compression check
+ 4.3.3. The operations demanding removal of the engine
4.3.4. Removal of auxiliary components of the engine
4.3.5. Removal and installation of the valve of adjustment of pressure of oil
+ 4.3.6. A gear belt
4.3.7. Removal and installation of the mechanism of a tension of a gear belt and rollers
4.3.8. Removal, check and installation of camshafts
+ 4.3.9. A head of the block of cylinders
4.3.10. Removal and installation of the oil pallet and маслоотражательной plates
+ 4.3.11. The oil pump
4.3.12. Removal and installation of the valve of the thermostat of an oil radiator
+ 4.3.13. Pistons and rods
4.3.14. Removal and flywheel installation
+ 4.3.15. Replacement of sealing rings
4.3.16. Removal, check and installation of bearings of a cranked shaft
4.3.17. Check of components of the engine
4.3.18. Removal and engine installation
4.3.19. Start of the engine after major repairs
+ 4.4. Diesel engines 16D and 16DА
+ 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes
|
Look the corresponding description in subsection 4.1.16.1, subsection 4.1.16.2, subsection 4.1.16.3, subsection 4.1.16.4, subsection 4.1.16.5, subsection 4.1.16.6, subsection 4.1.16.7 taking into account the following additional information.
CAMSHAFTS
| PERFORMANCE ORDER |
| 1. Remove camshafts and check up a condition of working surfaces of bearings and cams on presence of dot corrosion and deterioration. By a micrometer measure diameters of necks of bearings of camshafts. |
| 2. In the presence of deterioration or damages replace a camshaft. In the presence of deterioration of bearings of a camshaft it is necessary to replace a head of the block of cylinders. |
| 3. Establish camshafts in a head of the block of cylinders and measure axial люфт camshafts. If люфт exceeds admissible limits, it is necessary to replace camshafts and / or a head of the block of cylinders. |
|
GEAR BELT
At installation it is necessary to use each time a new gear belt. |
|
