Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
- 10. Transmissions and power shafts
   - 10.1. A mechanical transmission
      10.1.1. A technical characteristics
      10.1.2. Oil replacement in a transmission
      10.1.3. Removal and installation of the lever of a gear change
      10.1.4. Removal and installation of a cable of blocking of inclusion of a reverse gear
      10.1.5. Removal, installation and adjustment of draught of a gear change
      10.1.6. Replacement of sealing rings
      10.1.7. Check, removal and installation of the switch of lanterns of a backing
      10.1.8. Removal and installation of a drive of a speedometer
      + 10.1.9. A transmission
   + 10.2. An automatic transmission
   + 10.3. Power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

10.1.4. Removal and installation of a cable of blocking of inclusion of a reverse gear

THE GENERAL DATA

The blocking mechanism prevents casual inclusion of a reverse gear. Blocking is released after a raising of the handle located under the handle of the lever of a gear change. The top part of a cable is attached to the handle, and bottom is attached to blocking draught.

PERFORMANCE ORDER

1. At cable rupture replace it as follows, but preliminary check up that there are spare parts.

2. Remove the gear change lever.

3. Remove from the lever of a gear change the handle, preliminary its heating in hot water. Even at removal нагретой handles it can break.

4. Take a spring located under the handle.

5. Unscrew the screw from the top part of the lever of a gear change.

6. Beat out cylindrical pins, fastening plastic муфту and поводковый the lever to the basis of the lever of a gear change. It is probable that at removal plastic муфта it will be damaged.

7. Remove a cable and a cable tip.

8. Installation is made in sequence, return to removal.