Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
- 5. System of cooling, heating and ventilation
   5.1. A technical characteristics
   5.2. Removal and installation of hoses of system of cooling
   5.3. Removal, check and radiator installation
   5.4. Removal, check and thermostat installation
   5.5. Removal and installation of the water pump
   5.6. Check, removal and installation of the electric fan of a radiator
   + 5.7. Check, removal and installation of electric gauges of system of cooling
   5.8. Heating and ventilation system
   - 5.9. Elements of system of heating
      5.9.1. Removal and installation of the control panel by a heater
      5.9.2. Removal and installation of the engine of the fan of a heater
      5.9.3. Removal and installation of a radiator of a heater
      5.9.4. Removal and installation of the case of the distributor of air
      5.9.5. Removal and installation snuffled also lattices
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes


944881c0

5.9.5. Removal and installation snuffled also lattices
THE GENERAL DATA

Removal from the panel of devices of a lateral nozzle from a loudspeaker lattice

The flat lattices located from two parties of the panel of devices, can close a loudspeaker also.

PERFORMANCE ORDER
1. Lateral and central nozzles act in film after their pressing downwards. Casings snuffled fasten the screw and скобами which at removal will be broken (the screw of fastening of a casing of a lateral nozzle of ventilation it is specified by an arrow).
2. A casing of the central nozzle of system of ventilation fasten two screws above and two below (the top screw of fastening is specified by an arrow). The bottom screws also крепят radio receiver furnish. In a casing of the central snuffled hours which are necessary for disconnecting at casing removal can be established.
3. Removal of air lattices from a car outer side can be made, using a screw-driver edge as the lever.
4. All removed elements are established simple защелкиванием or fastening by screws.