Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
- 3. Greasing system
3.1. Specifications
3.2. An engine oil choice
3.3. The gauge of pressure of oil
3.4. Check of level of engine oil
3.5. Engine oil replacement
3.6. Replacement of the oil filter
3.7. The oil pump of engine SOHC
3.8. The oil pump of engine DOHC
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes
|
|
PERFORMANCE ORDER |
| 1. The control lamp of pressure of oil lights up after inclusion of ignition and dies away after engine start-up. If the lamp does not burn after ignition inclusion check up the gauge of pressure of oil, the ignition lock, a lamp and electric wires. | | 2. If there is a pressure at inclusion of ignition and there is no pressure after engine start-up, means, the gauge of pressure of oil is perfectly in order and it is necessary to check up a lamp and electric wires. Pressure of switching of the gauge of pressure of oil: 14,71–29,42 кПа | |
| 3. The special tool 09260–32000 tighten the gauge of pressure the demanded moment. The inhaling moment:
The gauge of pressure of oil in gathering with the level gauge: 8–12 Н•м
The gauge of pressure of oil: 13–15 Н•м |
|
Check
| PERFORMANCE ORDER |
|
| 1. An ohmmeter check up conductivity of connection between the plug of the gauge and the block of cylinders. In the absence of conductivity, replace the gauge. | | 2. An ohmmeter check up conductivity of connection between the plug of the gauge and the block of cylinders at the put forward rod of the gauge. If conductivity is available even at the put forward rod, replace the gauge. |
| 3. However, if there is no conductivity even at the appendix of vacuum 50 кПа to a gauge aperture, the gauge works properly. | |
|
|
