Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes


944881c0

11.20. Replacement brake колодок a manual brake on back disk brakes
THE GENERAL DATA

On models with back brake disks the manual brake works irrespective of hydraulic brake system. Are thus used brake Pads drum-type type, and as a brake drum the internal part of a brake disk is used.

PERFORMANCE ORDER
1. Remove a back brake disk.
2. Disconnect a cable (it is specified by an arrow) manual brake and a returnable spring from a control lever of a manual brake on a brake board.
3. Using flat-nose pliers, remove plates of springs of fixing brake колодок, pressing a plate and turning it on 90 °.
4. Remove springs and take a pin (it is specified by an arrow) clamp back brake Pads.
5. Remove brake Pads together with springs, a regulator and разжимной a lath. Remove springs and divide brake Pads.
6. Being careful and security measures, clear all traces of a brake dust from a brake drum, a brake board and колодок.
7. Apply a thin film high-temperature greasing on a regulator carving, then reduce length of a regulator to is minimum possible.
8. Apply a thin film high-temperature greasing on contact places (are specified by arrows) brake колодок with a brake board.
9. Collect Pads a manual brake, a regulator and разжимную a lath, then connect brake Pads returnable springs.
10. Establish knot колодок a manual brake on a brake board, thus the leader brake колодку establish on a clamp pin.
11. Establish a pin of a clamp of the second brake Pads, then establish springs and spring plates.
12. Establish a cable of a manual brake and a returnable spring on a control lever of a manual brake.
13. Establish a brake disk.
14. Adjust a manual brake.