Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Prorolling of hydraulic brake system
   11.3. Brake pipelines and hoses
   + 11.4. Lobbies brake Pads
   11.5. Replacement back brake колодок on disk brakes
   11.6. Replacement back brake колодок on drum-type brakes
   11.7. Check, removal and installation of a forward brake disk
   11.8. Check, removal and installation of a back brake disk
   11.9. Removal, check and installation of a brake drum
   + 11.10. A support of a forward brake
   + 11.11. A support of a back disk brake
   + 11.12. The back working brake cylinder
   + 11.13. The main brake cylinder
   + 11.14. Valves of adjustment of pressure
   11.15. Replacement of the unidirectional valve of the vacuum amplifier of brakes
   11.16. Check, removal and installation of the vacuum amplifier of brakes
   11.17. Removal and installation of a pedal of a brake
   11.18. Removal and installation of a cable of a manual brake
   11.19. Removal and installation of the lever of a manual brake
   11.20. Replacement brake колодок a manual brake on back disk brakes
   + 11.21. Antiblocking system of brakes (ABS)
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes


944881c0

11.3. Brake pipelines and hoses
THE GENERAL DATA

Brake tubes are applied to transfer of a brake liquid from the main brake cylinder to wheel brake cylinders. Connections of tubes with brake cylinders and switching centres are made конусными муфтами. The ends of tubes are pressed out and have the cone-shaped form for the corresponding size конусных carving apertures in brake cylinders or switching centres.

Before обжатием the ends of tubes the lock nut which after ввинчивания a cone-shaped surface in конусное the basis of a carving aperture presses and герметизирует a tube is put on them.

Brake hoses carry out mobile communications between mobile and motionless parts of the car. For reduction of losses of a brake liquid at removal of working brake cylinders clips for пережатия brake hoses are used.


The prevention

At installation of a new brake tube or a brake hose be convinced that they are densely fixed in arms and are on sufficient distance from moving or heating up details.

Upon termination of installation check up level of a brake liquid in the main brake cylinder and add it if necessary. Remove air from brake system and cautiously check up work of brakes before beginning car operation.