Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      + 6.1.11. Carburettors
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

6.1.16. Removal and installation of a final collector
Removal

PERFORMANCE ORDER

L models 1,2

1. Lift and fix on supports a forward part of the car.

2. Working under the car, disconnect from a final collector a reception exhaust pipe for what unscrew two bolts and remove springs.

3. Remove the air filter.

4. Unscrew six bolts, крепящих a final collector to a head of the block of cylinders, and remove a collector and a collector lining.

Models 1,3, 1,4 and 1,6 l

5. Remove the air filter. Remove an air inlet of air warmed up by a final collector.

6. Unscrew nuts or bolts and disconnect from a final collector a reception exhaust pipe.

7. Unscrew nuts of fastening of a final collector and remove a collector from hairpins. Remove a lining of a final collector.

Installation

PERFORMANCE ORDER

L models 1,2

1. Installation is made in sequence, return to removal, but thus it is necessary to use a new lining. A tightening of bolts of fastening of a collector make gradually and in regular intervals, since the middle to edges.

Models 1,3, 1,4 and 1,6 l

2. Installation is made in sequence, return to removal, but thus it is necessary to use a new lining. Tighten nuts of fastening of a collector gradually and consistently, beginning from the centre to edge. At connection of a reception exhaust pipe to a final collector use a new lining.