Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      + 6.1.11. Carburettors
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

6.1.18. Removal and exhaust system installation

THE GENERAL DATA

Exhaust system problem is tap of the fulfilled gases in atmosphere so that they even in a minimum quantity have not got to car salon, and also decrease in noise level of the engine. That the exhaust system could carry out the functions, it should be in good repair. The exhaust system condition influences also capacity of the engine and the fuel expense.

Removal

PERFORMANCE ORDER

1. For exhaust system removal lift a forward or back part of the car and fix on supports.

2. The exhaust system consists of three or four sections. Forward and back sections of an exhaust system can be removed independently from each other, but for removal of average section it is necessary to disconnect adjacent elements of fuel system. It is the most convenient to remove an exhaust system in gathering.

3. For removal of forward or back section of an exhaust system remove подпружиненные clips which connect exhaust system sections.

4. Remove the rubber pillows supporting section of an exhaust system, and at removal of forward section unscrew bolts, fastening a reception exhaust pipe to a final collector.

Installation

PERFORMANCE ORDER

1. At connection of sections of an exhaust system use антипригарный structure. Check up a condition and, if necessary, replace clips, rubber pillows, consolidations and linings (in drawing – the graphite sealing ring established in elastic connection of sections of an exhaust system).

2. At exhaust system installation arrange it so that the exhaust system weight was in regular intervals perceived by rubber pillows then tighten bolts of fastening of clips.