Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
- 8. Coupling
8.1. Specifications
8.2. Adjustment of a pedal of coupling
8.3. The main cylinder of coupling
8.4. A coupling pedal
8.5. The working cylinder of coupling
8.6. Search and elimination of malfunctions
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes
|
1 – a hollow connecting bolt;
2 – a lining;
3 – a connector;
4 – a valve plate;
5 – a spring;
6 – the working cylinder of coupling;
7 – the union for air removal;
8 – a returnable spring; |
9 – the piston;
10 – a cover;
11 – a pusher;
12 – the case of the working cylinder of coupling;
13 – the union for air removal;
14 – a cover;
15 – a pusher;
16 – a hydraulic tube. |
Removal
| PERFORMANCE ORDER |
| 1. Disconnect a hydraulic tube of coupling. |
| 2. Turn out bolts of fastening of the working cylinder of coupling. |
|
Check
| PERFORMANCE ORDER |
| 1. Clear the dismantled details in solvent and blow all details and channels the compressed air. |
| 2. Check up the working cylinder of coupling and covers on absence of damages. |
|
Dismantling
| PERFORMANCE ORDER |
| 1. Lift the receiver, a valve plate, a spring, a pusher and a cover. |
| 2. Remove a dirt from an open aperture for connection of a hydraulic tube. |
| 3. Remove the piston and a sealing ring (cuff), submitting compressed air through an aperture for connection of a hydraulic tube. |
|
|
The prevention Close an aperture of the working cylinder pure rags to catch the piston pushed out by compressed air.
|
|
Check
| PERFORMANCE ORDER |
| 1. Check up the working cylinder of coupling on absence of damages. |
| 2. Check up covers on absence of damages. |
3. Measure internal diameter of the main cylinder of coupling. If the backlash between the piston and the cylinder exceeds admissible value, replace the main cylinder and / or the piston in gathering.
Backlash: 0,15 mm |
|
The prevention Measurement of internal diameter of the main cylinder of coupling spend in three sections (in the basis, the centre and top) in two perpendicular directions.
|
|
Assemblage
| PERFORMANCE ORDER |
| 1. Before assemblage grease with a liquid for coupling the piston and diameter расточки the cylinder and establish the piston in gathering. Liquid: brake liquid DOT 3
|
|
2. Establish a valve plate, a pusher and a cover. |
|
Installation
| PERFORMANCE ORDER |
| |
1. Before installation grease the plug, a pin, a washer and a pin with a head and an aperture under шплинт. Greasing: MOLYWHITE TA №2
|
|
2. Establish the cylinder of deenergizing of coupling and connect to it a hydraulic tube. |
|
|
|
