Hyundai Accent

Repair and car operation


Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
- 10. Axes and power shafts
   10.1. Specifications
   10.2. A power shaft
   10.3. A power shaft with SHRUS ball and Birfield type
   10.4. A power shaft with SHRUS Birfield and трипоидного type
   10.5. A rotary fist and a nave of a forward wheel
   10.6. A back axis
   10.7. Search and elimination of malfunctions
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

944881c0





10.2. A power shaft
1 – a lock ring;
2 – a power shaft;
3 – a rack of a forward suspension bracket;
4 – a rotary fist; 		5 – a brake disk;
6 – a nut, 220–260 Н•м;
7 – the bottom lever.

Removal
PERFORMANCE ORDER
1. Lift the car, fix on support and remove a forward wheel.
2. Turn out a nut of fastening of a power shaft to a nave of a forward wheel.
The prevention

At easing of a nut of fastening of a power shaft to a nave press a brake pedal to prevent проворачивание a wheel and a power shaft.
3. Merge трансмиссионную a liquid from a transmission.
4. A kapron hammer beat out a power shaft from a nave of a forward wheel. If the power shaft densely sits in a nave of a forward wheel, spray пропиточный aerosol solvent on area шлицов and then repeatedly screw a nut with a fillet so that it settled down flush with a shaft end face. Striking on a nut a brass hammer, beat out a power shaft from a nave.
5. Reject outside a rotary fist and get a power shaft from a nave of a forward wheel.
6. Insert mount between an internal SHRUS of a power shaft and a transmission and easy blow on mount take a power shaft from a transmission.
The prevention

Опирайте mount on edges картера transmissions.
Do not insert mount very deeply not to damage an oil sealing ring.
Do not pull for a power shaft as hinges of equal angular speeds will be thus damaged.
7. Get a power shaft from a transmission.
The prevention

Establish instead of power shafts special заглушки that the dirt has not got to a transmission.
Each time at power shaft removal replace a sealing ring of differential.

Check
PERFORMANCE ORDER
1. Check up protective covers of SHRUS of a power shaft on absence of damages and rubber hardening.
2. Check up spherical hinges on absence of deterioration.
3. Check up шлицы at power shaft end faces on absence of deterioration and damages.

Installation
PERFORMANCE ORDER
1. Grease a working edge of an oil sealing ring of differential.
2. Establish a new lock ring on the internal end of a power shaft. A push insert a power shaft into a transmission, thus a cut of a lock ring should settle down from below.
3. After installation pull a power shaft outside and be convinced that it is reliably fixed by a round clip.
4. Establish a washer under a nut of fastening of a power shaft to a nave the convex party directed outside, as is shown in drawing.