Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
- 11. A suspension bracket
   11.1. Specifications
   11.2. The bottom lever of a forward suspension bracket
   11.3. Replacement of the plug of the bottom lever
   11.4. Plug replacement (G) the bottom lever
   11.5. The forward stabilizer of cross-section stability
   11.6. A rack of a back suspension bracket
   11.7. Replacement of the plug of the back longitudinal lever of a back suspension bracket
   11.8. Replacement of the plug of the back cross-section lever (And and) a back suspension bracket
   11.9. The back stabilizer of cross-section stability
   11.10. Corners of installation of forward wheels
   11.11. Adjustment of a convergence of back wheels
   11.12. Deterioration of tyres
   11.13. Chains противоскольжения
   11.14. Wheel palpation
   11.15. A tightening of nuts of fastening of a wheel
   11.16. Shift of wheels
   11.17. Check of withdrawal and course instability of the car
   11.18. Care of disks from an aluminium alloy
   11.19. Search and elimination of malfunctions
   11.20. Diagnostics of deterioration of tyres
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes








11.9. The back stabilizer of cross-section stability
PERFORMANCE ORDER
1. Remove draught of the stabilizer of cross-section stability.
2. Check up a twisting moment which it is necessary to put for проворачивания pins of the spherical hinge of draught of the stabilizer.

If there are cracks in a protective cover, replace it and add greasing in the hinge.

Some times shake here and there a pin of the spherical hinge of draught of the stabilizer.

Screw on a pin of the spherical hinge самоконтрящуюся a nut and measure a twisting moment.

Twisting moment: 1,7–3,2 Н•м

If the twisting moment exceeds admissible values, replace draught of the stabilizer.

If the twisting moment considerably below admissible value, the spherical hinge can repeatedly be used, if it is not got jammed and has no excessive люфта.

3. Establish draught of the stabilizer and fix a nut so that the bottom nut settled down on distance And from a draught end face.

Distance (A) from an end face draught of the stabilizer to a nut: 4–6 mm