| 1. Remove the air filter. |
| 2. Unscrew three screws and uncover заслонки and a sealing ring. |
|
|
3. Without disconnecting hoses of giving of a cooling liquid from a cover заслонки, move a cover aside. Keep in mind that the loop () on the end of a bimetallic spring is combined with the drive lever заслонки (). |
| 4. Move the drive lever заслонки before full closing air заслонки. Establish the screw of the accelerated turns of idling on the highest step of a cam. |
| L models 1,3 |
|
5. Through a hose (it is specified by an arrow), the closest to the carburettor, create vacuum in the management block заслонкой. Slightly press the drive lever заслонки, turning the lever clockwise, and check up a backlash air заслонки, inserting a shaft of a drill of the demanded diameter. |
|
6. For adjustment rotate the screw located sideways of a casing заслонки. |
| Models 1,4 and 1,6 l |
| 7. Disconnect two vacuum hoses from the moving block заслонки and, using a small screw-driver, press the adjusting screw of moving заслонки before occurrence of notable resistance. Using a shaft of a drill of the corresponding diameter, measure a backlash between the bottom party air заслонки and a wall of the primary chamber. The backlash size should be equal to a small backlash заслонки the movings, resulted in subsection 6.1.1. |
| 8. If necessary establish a demanded backlash, rotating the adjusting screw in a corresponding direction. |
|
9. Establish a cover air заслонки, thus the loop of a bimetallic spring should be combined with the drive lever заслонки. Combine labels (are specified by arrows) in a cover and a casing заслонки and tighten screws of fastening of a cover. |
