Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. A transmission
   - 9.1. A mechanical transmission
      9.1.1. Specifications
      9.1.2. Check of level of oil
      9.1.3. Replacement трансмиссионного oils
      9.1.4. Replacement of an oil sealing ring of a power shaft
      9.1.5. Replacement of a cable of a drive of a speedometer
      9.1.6. Removal and transmission installation
      9.1.7. Transmission repair
      9.1.8. The gear change mechanism
      9.1.9. A hydraulic drive of coupling
      9.1.10. The gear change lever
   + 9.2. An automatic transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

9.1.6. Removal and transmission installation Mechanical transmission

1 – a bolt, 27–34 Н•м;
2 – a speedometer cable;
3 – a cover картера couplings;
4 – a bolt, 8–10 Н•м; 5 – a cable of a choice of transfers;
6 – a gear change cable;
7 – a starter.

Removal

PERFORMANCE ORDER

1. Disconnect, first of all, a wire from the negative plug of the storage battery, then – from positive. Turn out a drain stopper and merge in suitable capacity трансмиссионное oil from a transmission.

2. Remove the working cylinder of deenergizing of coupling.

3. Remove the case of the air filter.

4. Remove the storage battery and a battery support.

5. Remove a choice and gear change cable.

6. Disconnect a socket of the switch of light of a backing.

7. Remove a cable of a drive of a speedometer.

8. Disconnect a hydraulic tube of a drive of coupling and close the end of a pipe a suitable stopper.

9. Remove a casing from outside the engine and a casing sideways transmissions.

10. Remove forward and back arms.

11. Remove the right forward wheel.
12. Turn out a bolt of fastening of the spherical hinge of a forward rack.
13. Insert mount between an internal SHRUS of a power shaft and a transmission and easy blow on mount take a power shaft from a transmission.
14. Remove a starter.
15. The special adaptation 09400–29000 support the engine so that the engine weight was perceived by the adaptation.
16. Remove the left arm of a transmission.
17. Turn out the top bolts of fastening of a transmission.
18. Uncover картера couplings.
19. Support a transmission a jack.
20. Turn out the bottom bolts of fastening of a transmission.
21. Remove a casing of coupling and a conducted disk of coupling.
22. Remove a flywheel.

Installation

PERFORMANCE ORDER

Transmission installation is spent to sequences of return to removal.