Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. A transmission
   - 9.1. A mechanical transmission
      9.1.1. Specifications
      9.1.2. Check of level of oil
      9.1.3. Replacement трансмиссионного oils
      9.1.4. Replacement of an oil sealing ring of a power shaft
      9.1.5. Replacement of a cable of a drive of a speedometer
      9.1.6. Removal and transmission installation
      9.1.7. Transmission repair
      9.1.8. The gear change mechanism
      9.1.9. A hydraulic drive of coupling
      9.1.10. The gear change lever
   + 9.2. An automatic transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

9.1.9. A hydraulic drive of coupling

1 – a hose of a drive of coupling;
2 – a tube of a drive of coupling; 3 – the main cylinder of coupling;
4 – a coupling pedal.

Removal

PERFORMANCE ORDER

1. Turn out the union of prorolling and merge a brake liquid from a hydraulic drive of coupling.

2. Remove шплинт, a washer and a pin with a head and an aperture under шплинт.

3. Disconnect a hydraulic tube from the main cylinder of coupling.

4. Turn out a bolt of fastening of the main cylinder of coupling.

5. Remove clips of a hydraulic line of coupling.

6. Keeping from проворачивания a nut on a hose of a drive of coupling, turn away a nut on a tube.

7. Remove a clip of fastening of a hose of a drive of coupling and remove a hose from an arm.

8. Remove a hydraulic line of a drive of coupling.

9. Disconnect a tube from outside a coupling hose.

Check

PERFORMANCE ORDER

Check up a hose and a tube of a hydraulic drive of coupling on absence of cracks and damages.

Installation

PERFORMANCE ORDER

1. Connect a coupling tube from outside a coupling hose.

2. Temporarily, by hand, tighten nuts of fastening of a hose and a tube of a wire of coupling then tighten their demanded moment of an inhaling.
The inhaling moment: 13–17 Н•м

3. Establish a hydraulic line of a drive of coupling and fix clips.

4. Establish the main cylinder of coupling.

5. Before installation grease the plug, a pin, a washer and a pin with a head and an aperture under шплинт.
Greasing: J310a, NLGI №2

6. Establish a pusher on a coupling pedal.

7. Fill in a liquid in a coupling tank.

8. Remove air from hydraulic system of a drive of coupling