Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
- 2. The engine
   + 2.1. Engines SOHC
   - 2.2. Engines DOHC
      2.2.1. Specifications
      2.2.2. Compression check
      2.2.3. A gear belt
      2.2.4. A poliklinovoj belt
      2.2.5. Engine support
      2.2.6. A forward cover
      2.2.7. The air filter (ACL)
      2.2.8. A head of cylinders
      2.2.9. Camshafts
      2.2.10. Replacement of a saddle of the valve
      2.2.11. Replacement of the directing plug of the valve
      2.2.12. The valve
      2.2.13. Rods
      2.2.14. A cranked shaft
      2.2.15. A flywheel
      2.2.16. The piston
      2.2.17. A final collector
      2.2.18. An inlet collector and the air chamber
      2.2.19. The block of cylinders
      2.2.20. Removal and engine and transmission installation
      2.2.21. System of release of the fulfilled gases
      2.2.22. Search and elimination of malfunctions
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes


944881c0






2.2.2. Compression check If the engine works badly or with faults, check up system of ignition and fuel system.

If it was not possible to find the reason of bad work of the engine, inspect a compression. Regular carrying out of this check will allow you to warn occurrence of malfunctions in advance also.

PERFORMANCE ORDER
1. Check up engine oil level. Be convinced that the starter works normally, and the storage battery is completely charged.
2. Start the engine and warm up it to temperature 80–95°C.
3. Switch off the engine and remove from spark plugs tips of high-voltage wires.
4. Turn out spark plugs.
5. Turn a cranked shaft of the engine.
6. Screw a tip компрессометра in a spark plug aperture.
7. Completely open throttle заслонку.
8. A starter turn a cranked shaft of the engine approximately on 4 turns and on a device scale define a compression.

Compression: 1,47 мПа
Is minimum admissible compression: 1,37 мПа

9. Repeat steps 6–8 on other cylinders.
10. If a compression low in all cylinders, through apertures for spark plugs fill in in cylinders on нескольку a thaw of engine oil and repeat steps 6–8.

1) If oil pouring lifts a compression, probably, piston rings are worn out.
2) If a compression remains at the same level, probably, valves have burnt through or the lining of a head of cylinders is damaged.
3) Screw spark plugs and connect to them high-voltage wires.

The inhaling moment: 20–30 Н•м