| 1. Start the engine and warm up it to normal working temperature, then switch off the engine and remove the air filter. |
| 2. Extend the handle of management air заслонкой against the stop and check up that draught has turned in completely closed position against the stop the lever. If necessary adjust a cable of management air заслонкой. |
|
3. With completely extended handle of management air заслонкой start the engine and check up that between air заслонкой and диффузором it is possible to insert a shaft of a drill in diameter resulted in subsection 6.1.1. |
|
4. If necessary ослабьте a counternut and, rotating the adjusting screw (it is specified by an arrow), located over the vacuum chamber, adjust a backlash. |
| 5. Switch off the engine, tighten a counternut and establish the air filter. |
