Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   - 6.1. Models with the carburettor
      6.1.1. A technical characteristics
      6.1.2. Use unleaded gasoline
      6.1.3. Removal and installation of the case of the air filter
      6.1.4. System of adjustment of temperature of air arriving in the engine
      6.1.5. Check, removal and installation of the fuel pump
      6.1.6. Removal and installation of the gauge of level of fuel
      6.1.7. Removal and installation of a fuel tank
      6.1.8. Removal, installation and adjustment of a cable of an accelerator
      6.1.9. Removal and installation of a pedal of an accelerator
      6.1.10. Removal, installation and adjustment of a cable of management air заслонкой
      - 6.1.11. Carburettors
         - 6.1.11.1. Adjustments on the carburettor 32 TL
            6.1.11.1.1. Turns of idling and quality of a fuel mix
            6.1.11.1.2. The accelerated turns of idling
            6.1.11.1.3. A backlash air заслонки
            6.1.11.1.4. Productivity of the accelerating pump
         + 6.1.11.2. Adjustments on the carburettor 35 PDSI
         + 6.1.11.3. Adjustments on the carburettor 1В1
         + 6.1.11.4. Adjustments on the carburettor 2Е3
         + 6.1.11.5. Adjustments on carburettor Varajei II
      6.1.12. Check of the electromagnetic valve of a stopping delivery of fuel
      6.1.13. Removal and carburettor installation
      + 6.1.14. Carburettor repair
      6.1.15. Removal and installation of an inlet collector
      6.1.16. Removal and installation of a final collector
      6.1.17. Removal and installation of a heater of an inlet collector
      6.1.18. Removal and exhaust system installation
   + 6.2. Models with system of injection of fuel
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes


944881c0

6.1.11.1.4. Productivity of the accelerating pump
PERFORMANCE ORDER
1. With the carburettor established in the car, and the removed air filter start the engine for some minutes in an idling mode, then switch off it.
2. Looking in диффузор the carburettor, manually open throttle заслонку. At opening throttle заслонки there should be a stream of fuel from the accelerating pump. In the absence of a fuel stream, probably, the accelerating pump is faulty or channels of giving of fuel of the accelerating pump are blocked.
3. This check defines only working capacity of the accelerating pump. For more exact check of the accelerating pump it is necessary for removing from the engine.
4. Fill поплавковую the chamber of the carburettor with fuel and establish the carburettor over a measuring vessel.
5. Ten times with an interval in three seconds completely open throttle заслонку. Measure quantity of the fuel submitted the accelerating pump, and compare it to the data resulted in subsection 6.1.1. Adjustment of the accelerating pump is not provided and possible only its clearing or replacement of the worn out or faulty details.