Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. A suspension bracket and a steering
   12.1. A technical characteristics
   + 12.2. A rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. The bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   + 12.7. A nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. The back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a self-levelled back suspension bracket
   12.15. Removal and steering wheel installation
   + 12.16. A steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draught
   + 12.19. Steering transfer
   12.20. Removal of air from system of a steering with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation пополнительного a tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. A body
+ 14. Electric schemes


944881c0

12.14. Check of system of a self-levelled back suspension bracket
PERFORMANCE ORDER
1. On completely empty car establish a manometre on the air valve and check up that pressure in a control system of a self-levelled back suspension bracket makes 0,8 bar. Otherwise adjust pressure.
2. Establish the car on an equal horizontal platform and measure distance from the centre of a back bumper to the earth.
3. From the measured distance subtract 50 mm and write down the received result.
4. Completely load the car and check up that the car bumper was established at earlier calculated height.
5. If necessary lift pressure in system, but do not exceed it above 5 bar.
6. Completely unload the car and reduce pressure in system to 0,8 bar and check up that the bumper was established on originally measured height.
7. Do not maintain the empty car with a high pressure in a control system self-levelled a back suspension bracket.