| 1. Remove a wire of weight from the accumulator. |
| 2. Unscrew screws and remove the bottom casing of a steering column. |
| Contact group of the lock of ignition |
| 3. Disconnect contact group from the ignition lock. |
| 4. Unscrew two screws and take contact group of the case of the lock of ignition. |
| 5. Installation is made in sequence, return to removal. |
| 6. Check up, that the central part of contact group was correctly combined with a rod of the cylinder of the lock. |
| The lock cylinder |
| 7. Insert a key into the lock of ignition and turn it in position II. |
|
8. Using a steel core (it is specified by an arrow) in diameter 3 mm, inserted through an aperture in a casing of the lock of ignition, release a clamp and take the cylinder of the lock of ignition for the ignition key. |
| 9. Before installation of the new cylinder of the lock of ignition insert the ignition key and turn it in position II. |
| 10. Insert the cylinder into a casing of the lock of ignition before its accurate fixing by a spring then take a key. |
| 11. Connect a weight wire to the accumulator and check up work of the lock of ignition. |
| 12. Establish the bottom casing of a steering column. |
