Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
- 2. The engine
   - 2.1. Engines SOHC
      2.1.1. Specifications
      2.1.2. A gear belt
      2.1.3. Check of a tension of a gear belt
      2.1.4. Adjustment of a tension of a gear belt
      2.1.5. A poliklinovoj belt
      2.1.6. Engine support
      2.1.7. A forward cover and the oil pump
      2.1.8. The air filter (ACL)
      2.1.9. A head of cylinders
      2.1.10. Коромысла
      2.1.11. Hydraulic jacks of backlashes of valves
      2.1.12. Replacement of a saddle of the valve
      2.1.13. Replacement of the directing plug of the valve
      2.1.14. The valve
      2.1.15. A camshaft
      2.1.16. Rods
      2.1.17. A cranked shaft
      2.1.18. A flywheel
      2.1.19. A piston finger
      2.1.20. A final collector
      2.1.21. An inlet collector and the air chamber
      2.1.22. The block of cylinders
      2.1.23. Removal and engine and transmission installation
      2.1.24. System of release of the fulfilled gases
      2.1.25. Search and elimination of malfunctions
   + 2.2. Engines DOHC
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes


944881c0






2.1.18. A flywheel
1 – a gear wreath;
2 – a flywheel;
3 – a bolt, 130–140 Н•м;
4 – a drive plate;
5 – an adjusting plate;
6 – a bolt, 130–140 Н•м;
7 – an adjusting plate.

Removal

PERFORMANCE ORDER
1. Remove a transmission and coupling.
2. Turn out bolts and remove a flywheel. If on the car the automatic transmission is established, remove a drive plate. At a reversing of bolts block a flywheel from проворачивания.

Check

PERFORMANCE ORDER
1. Check up a condition of a surface of the flywheel contacting to a disk of coupling. In the presence of considerable deterioration replace a flywheel.
2. Check up palpation of a surface of the flywheel contacting to a disk of coupling.

Palpation: 0,1 mm

3. Check up a condition of a gear wreath of a flywheel on absence of damages and deterioration and if necessary replace it.

Installation

PERFORMANCE ORDER
Establish a flywheel or a drive plate on a cranked shaft. The special tool block a flywheel from проворачивания and tighten bolts of fastening of a flywheel.

The inhaling moment: 130–140 Н•м