Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection MFI
   6.5. A control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions ŤOBD-IIť
   6.7. Diagnostic codes of malfunctions, except ŤOBD-IIť
   6.8. Replacement of the fuel filter
   6.9. Replacement of the terminator of overflow (the double-thread valve)
   6.10. Replacement of the gauge of level of fuel
   6.11. A control system of engine MFI
   6.12. Fuel atomizers
   6.13. Throttle knot
   6.14. The power supply system with the carburettor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and starting arrangement adjustment
   6.19. Check and adjustment of a free wheeling of a cable of an accelerator
   6.20. A fuel tank
   6.21. The canister of catching of steams of fuel
   6.22. Replacement of the fuel filter
   6.23. The carburettor
   6.24. A cable and an accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburettor
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes


944881c0






6.17. Frequency of rotation of idling and adjustment of a fuel mix
PERFORMANCE ORDER
1. Remove the carburettor.
2. Fix the carburettor in a vice which sponges are closed by a soft material, access to the screw of adjustment of a fuel mix (MAS) should be thus open.
3. Drill an aperture in diameter of 2 mm in the central aperture for the screw of adjustment of a fuel mix (MAS), then рассверлите an aperture a drill in diameter of 3 mm.
4. Insert into the drilled aperture выколотку and beat out a stopper.
5. Establish the carburettor on the engine.
6. Start up the engine and warm up it to temperature of a cooling liquid 80–95°C.
Adjustment conditions

Headlights, the electric fan of a radiator and all electric consumers should be switched off, and the transmission should be established in neutral position.
7. Make a trip on the car during 5 mines for the speed of 48 km/hour or no more than on 5 with increase frequency of rotation of a cranked shaft to 2000–3000мин–1.
8. Then allow to the engine to work idling within 2 minutes
9. Adjust the maintenance WITH and frequency of rotation of idling, rotating the screw of adjustment of frequency of rotation of idling (SAS-1) and the screw of adjustment of quality of a fuel mix (MAS).

The maintenance WITH on frequency of idling: 2,0ą 0,25 %
Frequency of rotation of idling of the engine of 1,3 l with a mechanical transmission: 850ą100 mines-1

10. Establish a stopper closing access to the screw of adjustment of quality of a fuel mix.