Hyundai Accent

Repair and car operation

Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
- 6. Fuel system
   6.1. Specifications (SOHC and DOHC)
   6.2. Check of the fuel pump
   6.3. Check of the pressure created by the fuel pump
   6.4. Checks of system of injection MFI
   6.5. A control lamp of malfunctions (MIL)
   6.6. Diagnostic codes of malfunctions «OBD-II»
   6.7. Diagnostic codes of malfunctions, except «OBD-II»
   6.8. Replacement of the fuel filter
   6.9. Replacement of the terminator of overflow (the double-thread valve)
   6.10. Replacement of the gauge of level of fuel
   6.11. A control system of engine MFI
   6.12. Fuel atomizers
   6.13. Throttle knot
   6.14. The power supply system with the carburettor
   6.15. Check of frequency of rotation of idling
   6.16. Adjustment of frequency of rotation of idling
   6.17. Frequency of rotation of idling and adjustment of a fuel mix
   6.18. Check and starting arrangement adjustment
   6.19. Check and adjustment of a free wheeling of a cable of an accelerator
   6.20. A fuel tank
   6.21. The canister of catching of steams of fuel
   6.22. Replacement of the fuel filter
   6.23. The carburettor
   6.24. A cable and an accelerator pedal
   6.25. Search and elimination of malfunctions of fuel system with the carburettor
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes

6.19. Check and adjustment of a free wheeling of a cable of an accelerator

PERFORMANCE ORDER

1. Start up the engine and leave it to work on frequency of rotation of a cranked shaft idling.

2. Check up that the cable of an accelerator has no free wheeling.

3. If the accelerator cable has a free wheeling, adjust it as follows:

– ослабьте an adjusting nut so that the lever throttle заслонки was free;
– Eliminate sharp excesses of a cable of an accelerator;
– To move a cable cover to the lever throttle заслонки, rotate an adjusting nut till the moment of the beginning of moving of the lever throttle заслонки, then turn away it on one turn back and законтрите an adjusting nut.