Hyundai Accent

Repair and car operation

1.62. A mechanical transmission Position of the lever of a gear change is traditional for five transfers of a forward course as it is represented in drawing.

Positions of the lever of a gear change

---

The prevention

At inclusion of transfer of a backing, after a full stop of the car, detain the gear change lever at least on 3 with in neutral position. After that move the lever to position of transfer of a backing.
At switching of the lever from position of 5th transfer to position of 4th transfer, watch to including by mistake the second transfer. Such sharp gear change can cause excessive increase in frequency of rotation of a cranked shaft of the engine (the marksman of a tachometre in a red zone) and can lead to engine damage.

---

Coupling use

Before transfer inclusion it is necessary to squeeze out completely a coupling pedal, and then slowly it to release. Repeated pressing a coupling pedal is necessary for making only after its reset. Do not hold a foot on a pedal of coupling during car movement. It can lead to deterioration of a disk of coupling. Do not use coupling for car deduction on a bias. For this purpose it is necessary to use a lay brake. Do not suppose sharp and repeating отпускания a coupling pedal.

Receptions of correct driving

Do not slide under a bias on neutral transfer. It is very dangerous. Always hold transfer of the included.

Be not accustomed driving at which it is necessary to brake sharply, and do not hold the left foot on a brake pedal constantly during driving. It conducts to an overheat of brakes and loss of efficiency of their work. On long descents it is necessary to apply braking by the engine to prevention of an overheat of brakes (including hill-climbing gears).

At hill-climbing gear inclusion, slightly brake the car. It will help to prevent excessive increase in frequency of rotation of a cranked shaft of the engine that can lead to its damage.

At a strong lateral wind reduce speed of movement of the car. It will improve its controllability.

Before inclusion of transfer of a backing be convinced that the car is completely stopped. Otherwise you can damage a transmission. To translate the lever in backing position, at first squeeze out a coupling pedal, translate the lever in neutral position, wait 3 with, and then translate the lever in backing position.

Be especially cautious at movement on slippery road, during braking, acceleration and a gear change. On slippery road, sharp change of speed of the car can lead to loss of coupling of wheels of the car with road and management loss over the car.

---

The prevention

At control loss over the car on high speeds the risk переворачивания the car considerably increases.
Control loss often occurs, when two or more wheels move down from a road track, and the driver tries to return the car back on road.
In a case if your car has moved down from a road track, avoid sharp turn of a steering wheel. Instead, lower speed of the car before again driving on road.

---

To take out a key from the ignition lock

PERFORMANCE ORDER

1. Turn the ignition key in position "АСС" ("the Additional equipment"). 2. Simultaneously press and turn the ignition key counter-clockwise from position "АСС" ("the Additional equipment") in position "LOCK" ("Blocking"). 3. The ignition key can be taken out from the lock only in position "LOCK" ("Blocking").

Recommended speeds for a gear change

For economic driving it is recommended to switch transfers on the speeds specified more low.

Transfer	Recommended speed
With 1st on 2nd or with 2nd on 1st	20 km/h
With 2nd on 3rd or with 3rd on 2nd	40 km/h
With 3rd on 4th or with 4th on 3rd	55 km/h
With 4th on 5th or with 5th on 4th	75 km/h