| 1. Establish the universal hinge on a shaft of a gear wheel of steering transfer. |
The prevention If the steering column is equipped by the mechanism of adjustment of an angle of slope, satisfy following conditions.
Default of these conditions can lead to deformation of an arm of an angle of slope therefore the lever of an angle of slope and a lever clamp can be damaged.
|
|
2. Before installation check up that on an arm there is an aperture for a hairpin.
1) If it so, fix the lever of an angle of slope in neutral position and establish a hairpin stopper in an aperture, then separate the lever of an angle of slope. |
|
2) Otherwise, fix the lever of an angle of slope about neutral position. |
|
3. Screw a bolt, крепящий to a steering shaft an U-shaped element of the universal hinge. The inhaling moment: 15–20 Н•м
|
|
4. Temporarily screw two assembly bolts. |
| 5. Screw two assembly nuts. The inhaling moment: 13–18 Н•м
|
| 6. Tighten the demanded moment these inhalings two assembly bolts. |
|
7. If the hairpin stopper is established, move a steering column to the bottom position. |
