| 1. Remove brake колодки. |
| 2. Disconnect a brake tube. |
| 3. Turn out bolts and remove the working brake cylinder. |
|
4. Remove dustproof covers from the working brake cylinder. |
| 5. Remove the piston. |
| 6. Get a returnable spring. |
7. Before assemblage of the working brake cylinder check up a condition of following details:
– The cylinder and the piston on absence of deterioration, damages and a rust;
– The case of the working brake cylinder on absence of damages and cracks;
– A contact surface of the piston and brake колодок on absence of deterioration. |
| 8. Assemblage is spent in sequence, return dismantling. |
|
|
The prevention Before assemblage clear the working brake cylinder изопропиловым spirit.
Before assemblage grease with a brake liquid the piston and the cylinder.
At assemblage it is necessary to use new cuffs and dustproof covers.
Be careful not to lose a steel ball of the drainage valve.
|
