Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
- 13. Brake system
   13.1. Specifications
   13.2. Antiblocking system of brakes (ABS)
   13.3. Prorolling of hydraulic system of a drive of brakes with scanner use
   13.4. Check and adjustment of position of a pedal of a brake
   13.5. Check of the vacuum amplifier of brakes
   13.6. Prorolling of hydraulic system of a drive of brakes
   13.7. Adjustment of a course of a lay brake
   13.8. The vacuum amplifier of brakes
   13.9. Brake tubes and hoses
   13.10. A pressure regulator
   13.11. A brake pedal
   13.12. Replacement of lobbies brake колодок
   13.13. A support of a forward brake
   13.14. The main brake cylinder
   13.15. Replacement brake колодок on back drum-type brakes
   13.16. Replacement of the working brake cylinder
   13.17. A lay brake
   13.18. Hydraulic block HECU ABS
   13.19. The gauge of frequency of rotation of a wheel
   13.20. Search and elimination of malfunctions
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes


Executive Protection / PSD, Head of State Special Agent Leadership course. The course focuses on the highest-level security missions. From Head of State Protection details perspective to State Department Diplomatic Security, undercover security executive protection training Pennsylvania covert operation. This includes physical event security, differing security layers, and leadership. The students will be tested by former Israeli Secret Service "Shin Bet" and US Secret Service special agent team leaders and chief security officers
944881c0






13.17. A lay brake
1 – the lever of a lay brake;
2 – an adjusting nut;
3 – a cable of a lay brake.

Removal

PERFORMANCE ORDER
1. Remove the back console.
2. Turn away an adjusting nut and remove a cable of a lay brake.
3. Remove the switch of a lay brake.
4. Remove knot of the lever of a lay brake.
5. Remove a wheel.
6. Remove a brake drum.
7. Remove brake колодки.
8. Disconnect a cable of a lay brake from the lever on brake колодке.
9. Remove a clip, крепящий a cover of a cable of a lay brake to a brake board.
10. Remove a pillow of back sitting.
11. Ослабьте clips of fastening of a cable of a lay brake also remove it from the car.

Check

PERFORMANCE ORDER
1. Check up action of the switch of a lay brake.
2. Check up a ratchet of the lever of a lay brake on absence of deterioration.
3. Check up a cable of a lay brake on absence of deterioration or damages.

Installation

PERFORMANCE ORDER
1. Check up marks presence on the left and right cables of a lay brake and establish them on the places.
2. Move the lever of a lay brake on brake колодке completely back and establish springs.
3. Establish condensing rings in a direction shown in drawing.
4. Grease with the recommended greasing a ratchet and the doggie of a ratchet of the lever of a lay brake.

The recommended lubricant: SAE J310, NLGI №2

5. After jack installation adjust a course of the lever of a lay brake.