Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
+ 9. A transmission
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
- 15. A central air
15.1. Specifications
15.2. The instruction on coolant application
15.3. Remarks at replacement of elements of a central air of air
15.4. Connection of elements of a central air of air
15.5. Check of elements of the central air established on the car
15.6. Installation of manometres for pressure measurement
15.7. Откачка atmospheric air from a central air
15.8. Gymnastics of a central air of air
15.9. Check of level of a coolant
15.10. Check of operational characteristics
15.11. Oil for greasing of the compressor of the conditioner
15.12. Relay check
15.13. The conditioner compressor
15.14. The plug of coupling and a pulley of the compressor of the conditioner
15.15. The coil of excitation of coupling
15.16. Compressor check on the car
15.17. The gauge of threefold (double) pressure
15.18. The fan and the condenser
15.19. The evaporator
15.20. Check of the thermostatic gauge (термистора)
15.21. The air filter of the evaporator
15.22. The heating and ventilation block
15.23. The heater block
15.24. The fan
15.25. Search and elimination of malfunctions
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes
|
If the central air contour has been opened and atmospheric air has got to it, it is necessary for pumping out, using the vacuum pump. If the system has been opened within several days, it is necessary to replace the receiver / a dryer.
Start the pump and open both valves. Leave the pump to work during 15 mines, then close valves and switch off the pump. The manometre of low pressure should show more than 700 мм.рт.ст. And this pressure should remain at the closed valves.
The prevention If low pressure does not reach more than 700 мм.рт.ст. During 15 mines, in a central air contour there is a leak.
If leaks in a central air is not available, open valves and continue pumping out during the subsequent 15 mines then close both valves and stop the pump. |
|
