Hyundai Accent

Repair and car operation



Hyundai Accent
+ 1. The maintenance instruction
+ 2. The engine
+ 3. Greasing system
+ 4. Cooling system
+ 5. The control, toxicity decrease
+ 6. Fuel system
+ 7. Ignition system
+ 8. Coupling
- 9. A transmission
   + 9.1. A mechanical transmission
   - 9.2. An automatic transmission
      9.2.1. Specifications
      9.2.2. A control lamp of malfunctions (MIL)
      9.2.3. Diagnostic codes of malfunctions
      9.2.4. Reading of codes of malfunctions
      9.2.5. Pressure check трансмиссионной liquids
      9.2.6. Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
      9.2.7. Check of level of a liquid in an automatic transmission
      9.2.8. Check of work of the lever of the selector
      9.2.9. Adjustment of the switch of indication of position of the lever of the selector
      9.2.10. Adjustment of the servo-driver of compulsory inclusion of a hill-climbing gear
      9.2.11. Pressure adjustment in a highway
      9.2.12. Replacement of an oil sealing ring of a power shaft
      9.2.13. Replacement of a cable of a drive of a speedometer
      9.2.14. Removal and transmission installation
      9.2.15. Transmission repair
      9.2.16. The selector lever
      9.2.17. Adjustment of a cable of management
      9.2.18. Repair of the lever of the selector
+ 10. Axes and power shafts
+ 11. A suspension bracket
+ 12. A steering
+ 13. Brake system
+ 14. A body
+ 15. A central air
+ 16. The electric equipment
+ 17. The appendix
+ 18. Electroschemes








9.2.4. Reading of codes of malfunctions
PERFORMANCE ORDER
With scanner HI-SCAN use
1. Switch off ignition.
2. Connect scanner HI-SCAN to a diagnostic socket.
3. Include ignition.
4. On scanner HI-SCAN consider codes of malfunctions.
5. Eliminate malfunction.
6. Erase diagnostic codes of malfunction.
7. Disconnect scanner HI-SCAN from a diagnostic socket.
With voltmeter use
8. Switch off ignition.
9. Connect the voltmeter to contact of 1 diagnostic socket.
10. Connect a L-wire to contact 15 diagnostic sockets.
11. The sample of an exit is shown on the voltmeter.
12. Consider diagnostic codes of malfunctions.
13. Erase diagnostic codes of malfunctions.