| 1. Move the selector lever to position N. |
|
2. Ослабьте a control lever counternut in a cable and lever junction. |
| 3. Move a control lever to position N. |
| 4. Turn the case of the switch of indication of position of the lever of the selector on distance to 12 mm and combine the wide end of a control lever with a switch ledge. |
| 5. Tighten bolts of fastening of the switch the moment of an inhaling 10–12 Н•м. |
| |
The prevention At turn of the case of the switch be careful not to damage a sealing ring.
|
| 6. Check up that the selector lever is in position N. |
| 7. Adjust nut position so that there was no sagging of a cable and the selector lever moved smoothly. |
|
8. Make a control trip and be convinced that the transmission is established in the position corresponding to each position of the lever of the selector. |
